Application of high-surface-area ZrO2 in preconcentration and determination of 18 elements by on-line flow injection with inductively coupled plasma atomic emission spectrometry

A flow-injection analysis (FIA) system incorporating a micro-column of ZrO2 has been used for the development of an on-line multi-element method for the simultaneous preconcentration and determination of Al, Bi, Cd, Co, Cr, Cu, Fe, Ga, In, Mn, Mo, Ni, Pb, Tl, V, Sb, Sn, and Zn by inductively coupled plasma atomic emission spectrometry (ICP-AES). The conditions for quantitative and reproducible preconcentration, elution, and subsequent on-line ICP-AES determination were established. A sample (pH 8) is pumped through the column at 3 mL min(-1) and sequentially eluted directly into the ICP-AES with 3 mol L(-1) HNO3. With a sample volume of 100 mL and an elution volume of 1 mL signal enhancement 100 times better than for conventional continuous aspirating systems was obtained for the elements studied. The reproducibility (RSD %) of the method at the 10 ng mL(-1) level in the eluate is acceptable - less than 8% for five replicates. Recoveries between 95.4% and 99.9% were obtained for the elements analysed. ZrO2, with a specific surface area of 57 m2 g(-1) and a capacity of approximately 5 mg g(-1) for the elements studied, was synthesized by hydrolysis of ZrCl4. The preconcentration system was evaluated for several simple synthetic matrices, standard water samples and synthetic seawater. The effect of foreign ions on the efficiency of preconcentration of the elements studied was investigated. The application of a micro-column filled with high-surface-area ZrO2 and flow injection inductively coupled plasma atomic emission spectrometry enables preconcentration and simultaneous determination of 18 elements at low concentrations (ng L(-1)) in different water samples.     

Multicolor photochromism of two- and three-component diarylethene crystals

Novel photochromic single crystals composed of three different kinds of diarylethenes, 1,2-bis(3,5-dimethyl-2-thienyl)perfluorocyclopentene (1a), 1,2-bis(2,5-dimethyl-3-thienyl)perfluorocyclopentene (2a), and 1,2-bis(2-methyl-5-p-methoxyphenyl-3-thienyl)perfluorocyclopentene (3a), have been prepared. The three-component crystals turned yellow, orange, red, purple, blue, green, or black upon irradiation with light of appropriate wavelengths. The colors of the crystals were thermally stable in the dark and completely bleached by irradiation with visible light. Such multicolored photochromic crystals have potential for the application to optoelectronic devices, such as multifrequency three-dimensional optical memory media or full-color displays.     

Double-chelation-assisted Rh-catalyzed intermolecular hydroacylation between salicylaldehydes and 1,4-penta- or 1,5-hexadienes

Intermolecular hydroacylation between salicylaldehydes 1, 26-40 and 1,4-penta- or 1,5-hexadienes 4-13 by Rh-catalyst proceeded under mild reaction conditions to give a mixture of iso- and normal-hydroacylated products 14-25, 41-55, and 57-60. In the hydroacylation reaction, chelation of both salicylaldehyde and diene to the Rh-complex plays a crucial role. The ratio of iso- and normal-hydroacylated products could be regulated by the addition of salicylic acid or amines. The effects of various Rh-complexes, solvents, and additives were examined, and the plausible mechanisms of the catalytic cycle were proposed on the basis of the deuterium-labeling salicylaldehyde experiments.     

Ultra-slow Relaxation Dynamics in Triglycine Sulfate and D-Sorbitol Studied by Time-resolved Spectroscopy

The ultra-slow modes with a relaxation time much longer than 1 ns are discovered by a time-resolved spectroscopy in uniaxial ferroelectric (NH₂CH₂COOH)₃H₂SO₄ (TGS) and in glass-former HOCH₂(CHOH)₄CH₂OH (D-sorbitol). A mode discovered in TGS is a thermal relaxational mode and is proved to be the physical origin of the central peak found by Brillouin scattering. Two modes are discovered in D-sorbitol. One is a thermal relaxational mode. The other is a mode characterized by the Kohlraush-Williams-Watts function with a relaxation time _R. A remarkable result is that _R indicates a critical behavior not at the liquid-glass transition temperature T_g =–7°C but at the ergodic to nonergodic transition temperature T_c=33°C.This revised version was published online in November 2005 with corrections to the Cover Date.     

可见光照射下丙炔光催化水解反应的研究 Ⅱ．钒离子对二氧化钛催化性能的影响

 研究了几种不同粒径的TiO2在CH3CCH和H2O的光催化反应中的催化活性．结果表明,利用离子注入法可以拓展纳米TiO2催化剂的光吸收区域,使其吸收带向可见光方向偏移,且偏移程度随着TiO2粒径的增大而增大;特别是注入V离子使TiO2催化剂在可见光区域具有光催化活性．V离子注入后,TiO2催化剂在紫外区域的光催化活性没有下降,但在可见光区域的光催化活性有所提高．在五种光催化剂中,具有中等粒径大小的P－25注入V离子后表现出最高的光催化活性．在太阳光直接照射下,这些光催化剂也具有较高的催化活性．     

Development of a cooled He*(23S) beam source for measurements of state-resolved collision energy dependence of Penning ionization cross sections: Evidence for a stereospecific attractive well around methyl group in CH3CN

A low-temperature discharge nozzle source with a liquid-N(2) circulator for He*(2(3)S) metastable atoms has been developed in order to obtain the state-resolved collision energy dependence of Penning ionization cross sections in a low collision energy range from 20 to 80 meV. By controlling the discharge condition, we have made it possible to measure the collision energy dependence of partial ionization cross sections (CEDPICS) for a well-studied system of CH(3)CN+He*(2(3)S) in a wide energy range from 20 to 350 meV. The anisotropic interaction potential energy surface for the present system was obtained starting from an ab initio model potential via an optimization procedure based on classical trajectory calculations for the observed CEDPICS. A dominant attractive well depth was found to be 423 meV (ca. 10 kcal/mol) at a distance of 3.20 A from the center of mass of CH(3)CN in the N-atom side along the CCN axis. In addition, a weak attractive well (ca. 0.9 kcal/mol) surrounding the methyl group (-CH(3)) has been found and ascribed to the interaction between an unoccupied molecular orbital of CH(3)CN and 2s atomic orbital of He*(2(3)S).     

Novel aggregation of [Ni(thiolato)2(amine)2]-type square planes assisted by silver(I) ions

Treatment of [Ni(L)][L =((-)SCH(2)CH(2)NH[double bond, length as m-dash]C(CH(3))-)(2)] with Ag(+) in water gave a pinwheel-like S-bridged Ni(II)(3)Ag(I)(2) structure in [Ag(2)[Ni(L)](3)](2+), which further reacted with [Ni(L)] to produce a Ni(II)(4)Ag(I)(2) structure in [Ag(2)[Ni(L)](4)](2+) and a Ni(II)(7)Ag(I)(4) structure in [Ag(4)[Ni(L)](7)](4+).     

Anion Binding Properties of N-Confused Porphyrins at the Peripheral Nitrogen

Ni(II), Pd(II), and Cu(II) complexes of N-confused porphyrin (NCP) exhibit anion binding properties through a hydrogen bonding interaction at the peripheral NH of confused pyrrole ring. The binding constants of the tetrakis(pentafluorophenyl)-NCP metal complexes (1-M, M= Ni, Pd, Cu) for various halide anions in CH₂C1₂ increase in the order of F^? > Cl^? > Br^? > I^?, respectively. Zwitterionic resonance form of the NCP complexes as well as interactions between halide anions and a pentafluorophenyl group are suggested to be important for efficient anion binding.     

Catalytic oxygenative degradation of 4-chlorocatechol by a nonheme iron(III) complex—Mechanism and prevention of catechol ester formation

We examined the oxygenative degradation of 4-chlorocatechol and 4-tert-butylcatechol catalyzed by iron(III)-tris(pyridin-2-yl)amine complex from the standpoint of repressing the formation of 4-chlorocatechol esters of the oxygenated products that causes the incomplete degradation of 4-chlorocatechol. Analysis of the products revealed that 4-chlorocatechol esters are formed by the reaction of muconic anhydride, which is the monooxygenated product, with catechols. It was found that the use of MeOH as the solvent instead of MeCN completely suppressed the catechol ester formation through the methanolysis of muconic anhydride, which greatly improves the degradation efficiency of 4-chlorocatechol.     

Synthesis of the ABCD ring of gambierol

A fully functionalized ABCD ring moiety of gambierol, a marine polycyclic ether toxin, was synthesized by the use of the oxiranyl anion strategy and reductive cycloetherification of a beta,delta-dihydroxy ketone.